Gemi Grade Report
Keldeo ex
White Flare
Scanned with GemiScan
Grade your own cards free.
Published September 13, 2026
Card Info
- Set
- sv10.5w
- Number
- 167
- Illustrator
- Yuu Nishida
Grading Summary
This Keldeo ex shows strong centering, clean surface presentation, and only light corner and edge wear. The main visible limitations are a few small white nicks on the borders and corners, with some scan glare affecting inspection on parts of the card.
Flags
Image Quality
• Parts of this scan are hard to inspect. Glare, overexposure, or low detail may reduce grading confidence.
• Parts of this scan are hard to inspect. Glare, overexposure, or low detail may reduce grading confidence.
1 back-side defect ignored due to scan quality.
Low-confidence card geometry detected (confidence 0.70, detected sides 2).
Subgrades
Grade Shape
Four-axis score profile
The card is very well centered left-to-right on both sides, with a noticeable but still controlled top-to-bottom shift that leaves more border at the bottom than the top. That overall alignment supports the strong centering result.
Corner wear is light but present on multiple corners, with small white nicks or breaks most evident on the back left and back right corners and subtler signs on the front corners. The visible wear is minor rather than heavy, which fits an 8-level corners result.
Observed
The edges show a few small whitish nicks and rough spots, most notably along the front right and front bottom edge, plus a small break on the back right edge. One back-edge blemish was in an image-quality-affected area and was excluded from scoring, but the remaining wear still justifies a modest reduction.
Observed
No surface-specific defects were detected in the art scans, and the card’s surface presents cleanly overall. Some glare and low-detail areas limit inspection in places, but there is no substantive surface wear visible to reduce the result.
What's holding this card back
Lowest axisCorners (8.0) is the lowest of the four axes. It's the main thing keeping this card from a higher grade.
The limiting defect is Corner Wear (minor, back).
Bringing corners up to the level of the next-weakest axis (Edges, 8.0) would be the single biggest improvement available.
Centering
Front
Back
Certificate
Verified
Keldeo ex
sv10.5w · 167
